| Rtlr,
You can go two ways with the DIY job.
One is just removing the switch and putting a loop/jumper between two connections in the bare plug left. This means that you can run the bike with the sidestand down but set off with the side stand down unless you make further mods.
Two involves running a wire from the neutral switch withyan electrical thingy in it to a the sidestand switch plug, this allows the engine to run with the sidestand down but as soon as you select a gear with eh stand down i.e. the neutral light goes out the engine cuts.
DIY method one is quick but could involve pain if you set off with the side stand down.
DIY method two takes a while, well it did for me, but is basically what all the proper kits do.
Unless you are reasonably confident with electrickery buy the proper kit!!
Ray.
[Edited on 30-4-2004 by Ray] |