Quote:
| Originally Posted by NBs996 The pin is loose, it should stay in the rubber boot when you remove the lever. All it does is sit inside that cylindrical thing in the lever. Just take the pivot bolt out and all will be obvious. |
It was doing the opposite - the pin wanted to pull out of the boot, but stay put in the cylinder.
I presume the actuator is not attached to anything at the master cylinder end and can safely be pulled out of the boot?
Quote:
| Originally Posted by NBs996 Maybe obvious, but... there's a 10mm nylock on the bottom of the pin which has to come off before you can unscrew the pin. |
I'd spotted that, but thanks for the heads up.