[JACKO748S]

Nige, cheers for the advice - much appreciated.

I took the slave cylinder off but still nowhere near enough slack there. When pulling the sprocket off, the frame was restricting complete removal.

I posted previously about the merits of doing this and most replies advised either going down 1 on front or up 2/3 on rear. Didn't seem to be any probs taking one off the front by the sounds of it.

Just had a new set put on the bike but they couldn't get the bigger rear in time - gutted now!!! That's why I went for the front option as it appeared to be an easier job for the more mechanically challenged (i.e. me).......

Anyone else out there help out???

Thanks.
Jacko.