Thread: Changing front sprocket on 748s
View Single Post
  #5  
Old 15-May-2004, 20:51
DJ Tera DJ Tera is offline
Registered Forum User
Big Twin
  
Posts: 1,724
Join Date: Aug 2002
Quote:
Originally posted by JACKO748S


I took the slave cylinder off but still nowhere near enough slack there. When pulling the sprocket off, the frame was restricting complete removal.

I posted previously about the merits of doing this and most replies advised either going down 1 on front or up 2/3 on rear. Didn't seem to be any probs taking one off the front by the sounds of it.

Thanks.
Jacko.

Go back and read thread again, specifically my post
Quote+Reply