Quote:
| Originally Posted by ells did wonder if it was heat related but after going to one cylinder it would go back to two just ny removing the load?
Could it be timing or is there one feed that does both cylinders?
How can I tell its one cylinder rather than the other??
Many Thanks
M |
Carb diaphragm not lifting properly, needle dislodged. You have 2 pickups one for each cylinder.
If its running on two at idle it is difficult to determine which is the offending one when it drops out dynamically. But you could reach down and pull the vertical plug lead off when on the move, when running on one. if it stops then its the front pot that is troublesome. If it keeps going on one then its the vert cylinder.