Quote:
| Originally Posted by killerBunny One for the boys who have the knowledge here. After my starter woes at brands and a fragged kill switch am rewiring the race bike. Too old for all that push startin.  Question is I still have the general relay between the kill switch and starter solenoid etc. Can I bypass this on the loom as seems to be just one more thing to fail. I have a kill switch which starts the pump on one button and spins it over on a seperate button. Also think the solenoid dead so can anyone advise where I could get one.  |
Yes you can Dean, it was my demise at Brands year before last. Using the same relay connector block a 50mm long piece of wire with a male lucar at each end and bridge between the power to the relay and where the relay power out is. Can't recall the location from memory but its not rocket science. Or will sort it at Snett for you.
