Quote:
| Originally Posted by Ghost Nowt wrong with just 5 cogs, I'm toward the sharp end and its no hindrance. So was Chris Clarke and Tom H, on little 583's and they are only 5 speed.  |
Spoke to Dallas about it earlier when he popped around, he didn't think there was much in it between a 5 or 6 speed box
Quote:
| Originally Posted by dunlop0_1 Kev. I went round to Waynes and the problem was this. The mesh between the gears on the 620 box is deeper than on the ST2. This put the shaft centers wider apart and therefore it physically would not fit into the bearings/crankcase. So Mike I figure that the 748 will not fit either.  |
Cheers for the info Neil, different issue than I thought then.
As you would say better off spending the money on tracktime