| JP. I would change the basket because you will find the Bucci basket has a better ergal. You will also need to remove the basket and pull out the long cyclinder thingy that sits over the shaft. Sorry I don't know what the part is called. You will also need to remove the rubber 'O' ring and put it on the one supplied with the Bucci. Pedro had broken 2 spider springs on his and when we took it out to return his bike back to std. The original cyclinder thingy was still in place. So it does have a purpose.
With the clutch pack, start with a friction plate, then a pressure plate, f/plate, dished plate dot towards you, then so on and so on. The final dished plate goes 2nd from lastand with the dot away from you. When you have all the plates fitted measure the distance from the last plate to the face of the center hub, it should be between 4 & 5mm. Any more or less than this, you will need to swop over a couple of plates to get the right measurement.
With regards to torque setting, this is std. Not sure what you mean by bevelled plates but ideally you want carbon or ally plates.
Jon
[Edited on 4-9-2004 by Jon]  |