Quote:
| Originally Posted by antonye |
Thanks for that and yes you could concider fitting a 20mm pin but then the rods would have to come off, shells, ti bolts £400 pounds later.
and then the cost of the bushes and new 20mm pins and then working out how to make up 1mm in the pistons or change the pistons as well. a shed load of cash
so the best bet is just to find a 21mm pin i have a couple of people looking but no luck as yest nd its the only thing stopping me putting together the engine.
But i have the rear head gasket to do on the 916 bip so i will pull the SP off the stand shelve it and wait.