Couple more questions!

aka.eric · 18-Aug-2005, 19:51

Where does the big plastic washer go,tried it inside the twistgrip,makes throttle too stiff.Is it right where it is,against the grip?

aka.eric · 18-Aug-2005, 19:57

Fuel pressure regulator,at the bottom is an outlet for small bore pipe,just visible in pic,what does it connect to.Advice so far been really appreciated,should be quiet for a time-parts on order,the ones that are still available.

nelly · 19-Aug-2005, 00:10

Easy one first. The pipe take off on the regulator simply vents to atmoshpere, as it is. nothing connects to it.

The plastic washer, from memory, sits betwen the throttle housing and the plastic tube the grip goes over. Not where it is, but behind the collar of the plastic tube. If it makes it tight, try some silicon spray to lube it a little.
Are you using stock grips? Renthal for instance will be grippier and the only solution may be to do away with the washer.

aka.eric · 19-Aug-2005, 13:24

Thank you.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

18-Aug-2005, 19:51	#1
aka.eric Registered Forum User 500SD Posts: 651 Join Date: Jul 2004 Couple more questions! Where does the big plastic washer go,tried it inside the twistgrip,makes throttle too stiff.Is it right where it is,against the grip? Reply

18-Aug-2005, 19:57	#2
aka.eric Registered Forum User 500SD Posts: 651 Join Date: Jul 2004 Fuel pressure regulator,at the bottom is an outlet for small bore pipe,just visible in pic,what does it connect to.Advice so far been really appreciated,should be quiet for a time-parts on order,the ones that are still available. Reply

19-Aug-2005, 13:24	#4
aka.eric Registered Forum User 500SD Posts: 651 Join Date: Jul 2004 Thank you. Reply