Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > screen fastners...

[moto748]

Originally posted by moto748
Don't know if you saw this thread, bossingit,

http://www.ducatisportingclub.com/xm...6958#pid152287


but I'm getting some kits together for these. As the screens have large-ish slotted holes, I'm planning on adding in a larger diameter plain washer to fit next to the screen, then the o-ring, then ordinary washer and nyloc nut.

Post here or U2U me if you're interested.

OK, I have finally got this together. I've taken some time lately to source some nylon washers; the ones I had got at first were a bit big, and showed quite a noticeable ring of white around the outside of the screw head. It was pointed out to me that some people might find that unsightly. So now I have managed to obtain some which are slightly smaller outside diameter. In fact, they're the same as the stock Ducati ones.

So, the screen kits do indeed include a large diameter stainless steel washer, as mentioned above.

This not required for the fairing kits, where the O-ring will got direct against the inside of the panel.


So I've got a couple of screen sets and a couple of fairing sets together initially.

I'm going to say £12 for the screen sets and £15 for the fairing sets.

So whaddya say? U2U me if interested.

Don't all rush at once!