What is the thread size - 749r tank breather plug

Carbon749 · 29-Jan-2006, 22:51

Would anyone know what thread size the breather bung on the 749r tank is ? and does anyone where to buy a cheap fitting for this to set up the race style breather.

The DP fitting and breather pipe with one way valve is over £110

Like the look, but, not prepaired to pay over a £100 for it.

[Edited on 29-1-2006 by Carbon749]

khu996 · 29-Jan-2006, 23:16

Whats the benefit of the breather style set up?

Carbon749 · 29-Jan-2006, 23:22

Quote:

[i]

Like the look, but, not prepaired to pay over a £100 for it.

[Edited on 29-1-2006 by Carbon749]

Pure bling value ... make the bike look different to all the other 749r.

khu996 · 29-Jan-2006, 23:52

Cool. As good a reason as any other!

How are you going to make it work? Are there any pics of the breather set up on race bikes?

Carbon749 · 29-Jan-2006, 23:56

According to JHP .... Fit the hose tail to the tank, length of pipe and valve. If you want to go the full mod, loop the existing breathers that come out of the tank near the ignition so that the two pipes that exit are connected together and then use a small blob of silicone in the breather hole under the fuel cap.

You can just fit the race style breather and leave the standard vent set up as well.

khu996 · 29-Jan-2006, 23:57

Sounds good.

If you're gonna do it, post some pictures when you're done.

nelly · 30-Jan-2006, 00:18

I have a feeling it'll be either 10mm fine or 3/8"bsp...............????

Only a hunch though. Definately check/measure before hand

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

29-Jan-2006, 23:16	#2
khu996 Registered Forum User Big Twin Posts: 1,216 Join Date: Aug 2004 Location: Swansea Whats the benefit of the breather style set up? Reply

29-Jan-2006, 23:52	#4
khu996 Registered Forum User Big Twin Posts: 1,216 Join Date: Aug 2004 Location: Swansea Cool. As good a reason as any other! How are you going to make it work? Are there any pics of the breather set up on race bikes? Reply

29-Jan-2006, 23:57	#6
khu996 Registered Forum User Big Twin Posts: 1,216 Join Date: Aug 2004 Location: Swansea Sounds good. If you're gonna do it, post some pictures when you're done. Reply

30-Jan-2006, 00:18	#7
nelly Registered Forum User Ducati Corse Posts: 3,134 Join Date: Jan 2002 Location: notts Mood: Bloo and Yellow.. and Red now ;) I have a feeling it'll be either 10mm fine or 3/8"bsp...............???? Only a hunch though. Definately check/measure before hand Reply