Ducati Sporting Club UK > General > Idle Chat > Let the mods begin - 749R

[Sharpy G]

Originally Posted by rcgbob44

A little more TI porn!

Same heads that Sharpy has used on his rear caliper but used on the front ones intead.

By the way, if you want to use these TI flnged bolts on your front calipers you will need to trim the flange very slightly to 16 mm dia & also trim down a 12 mm socket so that the O/D is 16 mm to match the flange on the bolt.

Unless you have proper modern radial calipers

[rcgbob44]

Snob!

[Sharpy G]

Originally Posted by rcgbob44

Snob!

[Sharpy G]

Back home after a much needed ride out on Sat 13th September



just compiling a list of all the things I want to do over the next few months, that's things for the bike and not the baby

[rcgbob44]

O look it`s one of those ugly bikes!

[Sharpy G]

Originally Posted by rcgbob44

O look it`s one of those ugly bikes!

A Laverda......where ?

[doogalman]

Originally Posted by Sharpy G

just compiling a list of all the things I want to do over the next few months,

How about getting Blob and his 998 out for a ride.

[Florence]

Originally Posted by Sharpy G

just compiling a list of all the things I want to do over the next few months, that's things for the bike and not the baby

The list is as far as it will go once Junior arrives You dont expect to play with your own toys do you??? You must play with Juniors I suggest you teach Junior to ride within the first week if you want the excuse to go on the bike

[Florence]

Originally Posted by doogalman

How about getting Blob and his 998 out for a ride.

Miracles Sharpy G can perform but the impossible.......... will take him some time!!

[rcgbob44]

Oi stop avin a go at me, it`s going out this week to the dyno (with a bit of luck) then for a thrash!