749 13 Tooth front sprocket - Any good?
 

Talon do a 13 tooth front which I was going to try with the std 38 tooth rear.
Has any one done this and what was the result
Cheers
G

not recommended 14 is the lowest you should go! someone will be along to tell you why soon, i would expect something to do with the strain it places on the the chain

Chain-Strain . . .
 

dont know about that but I think if you go to a 13 on the front it will start to wear the front of the actual swing arm out as the chain will end up too close!!

I run 14/36 on my 05 999s - frisky is the word!!!


Khushy

cant do it, 14 is the minimum. i run a 42 on the back of my 749s and it's now much more usable on the road. suprised my mate on his zx6 as well :)

I run my bike a 999S with a 13 and it was fine, but when I did the chain I went up on the rear and went back to a 14 on the front, what I think is you can run a 13 but do the back if you can, I did not care about the chain as I would have to buy a new one if I was to go up 3 teeth on the rear anyway, so the wear was not a problem,my chain lasted 10'000 and 7'000 was with 13 on the front,
:flame: :burn: :burn: