View Single Post
  #2  
Old 15-Mar-2012, 15:28
antonye's Avatar
DSC Member antonye antonye is offline
Administrator
Webteam
MotoGP God
Bikes: 748S, HM1100S, V4SP, Was: DD-A #111
 
Posts: 13,054
Join Date: Feb 2002
Mood: Passion Killer
The clutch and low speed control are two of the most often talked about things with Ducatis!

Yes the clutch is heavy, and if poorly adjusted (or excessively worn) then it will give you problems selecting gears. I've even found that a badly adjusted chain can make things worse. You will also learn to get used to the clutch. If you've come from pansy-ass cable clutches then you're just missing the necessary muscles, so a few hundred miles in the saddle will see you right.

If you're find it is not running perfectly, ie prone to stalling, then taking it to a knowledgeable specialist and getting it checked over and setup correctly can make the world of difference. It's usually down to the TPS/idle/balance setup that needs to be done *properly* and sometimes isn't even done right when they leave the factory! It may also explain the poor fuel economy if the fuelling trim is not setup right.

As for the low speed control - it's not meant to go slow
But yes, that does happen so a common change is to drop the front sprocket by one tooth (15t > 14t) which moves the speed/rev range to make it far more easier to ride around at low speed, at the expense of top speed.
It's a very cheap (and easy) mode to do, around £20 for the sprocket.


I'd rather die peacefully in my sleep like my Grandfather,
than screaming in terror like his passengers.- Jim Harkins

Ducati 748S | Ducati Hypermotard 1100S | Ducati Panigale V4 SP #876 | 600-620SS DesmoDue Racebike #111 <-- Sold!!
Quote+Reply