Ducati Sporting Club UK

Ducati Sporting Club UK (/msgboard.php)
-   DesmoDue - General Questions and Chat (/forumdisplay.php?f=107)
-   -   For Ghosty / Kev / anyone DD Mechanic. question (/showthread.php?t=84451)

bradders 12-Jun-2011 21:57

Hit it with the big hammer Craig ;) :lol:

Gbyte666 12-Jun-2011 22:39

Thanks again Phil, Yea I did try the misting in that I was spraying fuel into the top of the carb, and yea I had it slip a tooth at Mallory.
Ok its now at a point where its beyond me to continue as I dont have a compression gauge or how to use one.

I'll have to call my mechanic( Skids ) after Snett.

Thanks for your help Phil.

See you at Pembry hopefully

Craig

skidlids 12-Jun-2011 22:57

Craig we also disturbed the inlet manifold at Mallory when getting ready to take the cylinder head off, before I noticed the timing was a tooth out, so it could have an air leak, if so it would effect the fueling.

In the mean time I had better did out my compression checker (normally use a leak down check these days) I could pop over late tomorrow afternoon / early tomorrow evening with it if thats any help

Gbyte666 12-Jun-2011 23:42

If you have time Kev that would be most appreciated. Just give me a call and bollox to work I'll leave early

Craig

brummydave 14-Jun-2011 20:56

just a simple one that happened to me craig,check that all the blanking screws are still in the inlet manifold,i must have lost one at mallory and it would only run on 1 untill you revved it or applied choke,fitted new screw all good
all the best brummy dave 96:p

Gbyte666 14-Jun-2011 23:09

Hmmm Thx Dave.. I'm pretty sure I remember seeing one as we took it out to reseal it with liquid gaskit. But I'll sure go check that.

Craig

Ghost 14-Jun-2011 23:13

Quote:

Originally Posted by Gbyte666
Hmmm Thx Dave.. I'm pretty sure I remember seeing one as we took it out to reseal it with liquid gaskit. But I'll sure go check that.

Craig


There is one each side of each manifold I think Craig. :eek:

Gbyte666 14-Jun-2011 23:14

Ghosty---- you still hovering in here.
Kev did a compression test tonight and there is nothing wrong with that, if anything the fron pot is better.
Kev had the carb in a thousand peices and that all looks ok.
You can see the front pot spark plug is a little wet so fuel getting in, not igniting right ? As said before it will run on this one pot if you give it some revs but not smooth but no poping or anything.
What would you ( anyone )check next

thx


Craig

John W 14-Jun-2011 23:35

when you swapped the coils, did you try swapping the plug leads too ? (that assumes the will fit)

I had the same symptoms on my 998 when the front plug lead went bad.

Gbyte666 14-Jun-2011 23:50

Quote:

Originally Posted by Ghost
There is one each side of each manifold I think Craig. :eek:


Yup just ran out to the shed and there is just one in each & they are both there.
Thanks though Dave

Craig


All times are GMT +1. The time now is 05:08.

Powered by vBulletin 3.5.4 - Copyright © 2000 - 2025, Jelsoft Enterprises Ltd.
© Ducati Sporting Club UK