screen fastners...
 

anyone got any or know wheres good to get em??

Don't know if you saw this thread, bossingit,

http://www.ducatisportingclub.com/xm...6958#pid152287


but I'm getting some kits together for these. As the screens have large-ish slotted holes, I'm planning on adding in a larger diameter plain washer to fit next to the screen, then the o-ring, then ordinary washer and nyloc nut.

Post here or U2U me if you're interested.

moto...cool,well ill be up for the kit then,like you say the nut thread type thing is a tiny bit small for the hole,keep me posted

What's wrong with the orignal ones from a dealer?

Aren't they summat mad like nearly £5 EACH!!!!!!

I used M4x12 Stainless Button Head screws nylon washers from an online model makers suppliers and held everything togeter with Nyloc nuts so I didn't over tighten. No Well Nuts, no drilling and no hassle. I even replaced all the ones on the fairing as well.

Where did you get them from Mike?

I got a complete kit from pro-bolt, i think they were about £15 for the set, they do all colours and fit and look perfect.

Same here - bought the pro-bolt Ducati kit in black and they're no different from the originals except they cost a hell of a lot less and you can buy different colours.

Just make sure you get the right kit. I ordered through Busters and they sent a generic 8-piece screen kit rather than the Ducati specific one (SKDUC9) I ordered. Probably best to order direct from Pro-Bolt:

http://www.tastynuts.com/acatalog/Ta...__996_407.html

PS. Nice to meet you on Saturday and hope you get an engine cover sorted :D

Still planning to do this, as posted above, as soon as I get my ass into gear...