Number plate holder ?
 

I had a carbon number plate holder. I say had as it decided to touch the back wheel yesterday on the way home and lunched itself on the wheel ?.
so anyone know where I can get a better set up for holding the number plate and indicators.
im sure I have seen some that connect on to the small allen key in the middle of the exhausts ?.
any ideas let me know.
Cheers. K

I'll be making one for the 748 this week sometime out of ally, can always knock one up for you as well.

Was gonna say they are dead easy to make your own.


Hows the engine anyway??

Get the evoluzione one, spareshack sell them, perfect fit and really tidy

http://www.evoluzione.net/

The engine is going ok at the moment, done a couple of hundred miles now will wait until 500 then do a service and check clearances again.
Going to give it a proper test in Sept as me and the wife are going to spain.:roll:

BDG's carbon one on his R seems bigger, sits lower on his bike over the standard plastic unit when I was looking at his bike not so long back, sounds like the same with your ex on Keefer

Get one of these Keith, i have one on the Hybrid

http://www.evoluzione.net/assets/images/90021.jpg