INDICATOR RESISTORS
 

Having fitted some little indicators to my 748 they flash too fast

What type of resistor do i need and where and how do i fit it?

Thanks

Nick

Not sure on the cost but I know Harris do resisters

These are the ones I had to fit on my 748 with kellermann micro 1000 indicators.

My 748 needed two, my mates 998 didn't need any.

http://www.carbonworld.de/shop/produ...roducts_id=218

Just change the bulbs to the same watts as the old ones.

If you've gone for the LED type indicators then Hein Gericke sell the resistors (couple of quid for 2) you'll need 2 (one for the left and one for the right) and apply them across the +ve to -ve to add to the (now smaller) load that the indicators use.

Hope this helps

Jas