![]() |
Filler cap removal I am in trying to remove the filler cap to paint the tank on my 600ss DD bike. I have removed the 8 alan head grub screws in the alloy plate at which point I thought it would come out but no:puzzled: I have tried to twist ( both ways) and pull but no joy.:mad: Do I need to do something else to get it out. Mike |
They are damm tight,had the same problem with 888.Asked the same question,slide hammers mentioned!.Eventually it pulled out,reassemble with a bit of rubber grease on O ring. |
Cheers for that. Mike |
Remove the grub screws completely and spray some wd40 in the holes. Use a hammer shaft in the filler and "work" it to help the wd move around the o-ring. don't lever too hard else you'll dent the tank :o |
All times are GMT +1. The time now is 19:49. |
Powered by vBulletin 3.5.4 - Copyright © 2000 - 2025, Jelsoft Enterprises Ltd.
© Ducati Sporting Club UK