I wonder....
 

If you could transmogrify one of THESE kits to suit a T8?

The headers and spaghetti bits would fit surely, since ST4 headers fit a 888 and a Monster S4 is basically a naked ST? Might need a cut and slice on the can connectors but...

Dunno about the cams but...even if they wouldn't fit you could probably out them to a 916, S4 or ST4 owner

Not that I could afford it mind, but some of you might

[Edited on 26-4-2006 by Jools]

Oval cans on a 888??? :o Are you chicken oriental? Next you'll be suggesting a 999 fairing and yellow & green foam grips!

Go and wash your mouth out and get back to drooling over proper round zorsts like these:

headers and spaghetti would be fine but the pipes wouldn't fit - I think the subframe mount positions and hence can angles are different.
Cut and shut - or buy it, sell off the pipes and get a set of termi round cans to fit up...

Yes, I am chicken oriental. And how did you know I've been looking for a 999 fairing to fit as long as it's yellow and green to match the grips...

Truth is I wasn't looking much further back than the spaghetti and didn't twig the oval cans until it was too late...

Jools,

Spaghettis are around for 888s but they do take some searching out. A new one from Termi can be had for about £1800 to £2000 and by the time you've paid £1400 and P&P then modded the monster ones to suit...............