Wehey, got my zorsts back...
 

...and I'm well chuffed. After blowing a hole in my carbon cans last year I needed to get my exhausts repacked and resleeved. I decided to go Titanium and so sent them off to the guys at MHP in Surrey. These guys have done a superb job and I'm really happy, and it was half the cost of replacing the cans.

polished ends .. very 1998, joining the DOC mate ...???

and you know where you can shove them dont you Jamie, straight up yer rear end ....

Rattler will help hammer em in ... or NigelC is a dab hand at the zorst fitting malarkey ...

:roll::sing::roll::sing:

The whole exhaust was polished when I bought it, not that you'd notice it now ;)

The guys at MHP just re-buffed them up so I guess I need to get a bit of elbow grease in to the rest of it now :(

Why would I want to join you at the Doughnut Overeaters Club? You feeling lonely? :lol:

Looks strangely familiar !

Just read this post on the Overclockers site :P:D

Very nice !

My god!

Just look at the state of those floor tiles!

:lol:

I'll tell my mum you said that Ant, it's her floor :D

Totto, didn't know you still hung around over there as I hadn't seen your name for a while. Or do you go by a different name there now?

They're really nice...out of interest how much did it cost you?

Dont have the time ,just lurk no posting !

Two kids & a Ducati , tie up 99% of my time the putter has taken a rest for now , Till the next upgrade that is !:(

Total cost was £340. This included them to strip off the old carbon, re-pack the internals and then re-sleeve in titanium. All done by hand and the photo's really don't do them justice. Considering buying a new set of 54mm ti cans was around £600 I think it was well worth it.

Has the slut gone all bling!!!