Custom made washers, where from?
 

I need some custom made washers so that I can easily swap from a 620 rear wheel to a 600 one on the Monster. Dimensions should be 17mm ID, 24mm OD and 2mm thick. Well OD does not matter too much actually.

Any idea where I can source such bits?

Rich Casmore? Doesn't he run a fastners business??

Doh!
 

you'd need to know somebody it the trade....:rolleyes:

stock 16mm washers will have clearance on, 2mm thick but smallest OD standard is 30mm.
can you get by with this?

24mm - 17mm = 7mm. half of this either side 3.5mm. not much of a washer..

remind me of your address and I'll fix you up.

Hi Rich,

Thanks for your offer of help mate.
Indeed, they're more spacers than washers but a fellow ducatisti offered to make them for me. I'll PM you my address anyway for another business we had to finish ;)

Cheers,

Tonio.

running it into the ground.......:(

If they are spacers I should be able to turn those for you just need a bit of a drawing with dimentions.

Thanks for the offer Chaz, but a fellow Ducatisti is already on the case :)