Exhausts Fabricaters
 

Guys,

Just back from a trip to Nottingham to get my bikes exhaust system fabricated by Wayne Jackson, on the recommendation of Alan Parkes. I wanted a two into one under seat. The pros and cons you can decide!

Anyway, Wayne was just brilliant and I would recommend him to you all. I was looked after from start to finish and fed more tea than I could drink - and trust me that’s quite a lot! I had the end cans already, and he used a lot of the original headers which kept the cost down. Once made the system was polished and should go a lovely Ducati gold once run. Top job, top man and very reasonably priced.

I've put his web page link at the end of this post and when I work out how to a few pictures too. PM me if you want anymore info about the service, but it was truley fantastic. :saint:

http://www.jacexhausts.co.uk/index.html

got a bit waylayed today, will be calling him t'moro - bike arrives Sat am:D

Got any pictures? ..

I've been thinking about one of these for a while now

booked for Thursday!

Exhausts
 

A few pictures

Maybe camera angle but the can appears to be protruding past the rear wheel. Scrute reject item.

Good point Ghost however, it doesnt, lots of spare space. ( you even made me go and check it again! ) :saint:

had mine done today, top bloke, couldn't start it as flat battery! But should do the job ;)

looking forward to the extra mid range oomph :burn:

How much was that Bradders?

I think he charges about £250, depending on what you want/already have.