[antonye]

Posted here 'cos it's more relevant to this section...

My Sparco rearsets finally arrived today and they're exactly the same as DP ones!

I've been out in the garage fitting them, but have drawn a blank at fitting the rear brake lever as I can't get the pivot pin to go through it! I've removed the standard one but it's too big.

Looking at the DP ones, it's exactly the same so I'm thinking there must be a different size pin for this than the standard one - ie, slightly smaller.

Can anyone point me in the right direction?

I've also noticed that the little mushroom-headed bolt to press in the brake light switch is a different size (again smaller) but I can make do with a plain hex head if I can't get one of them either...