bearing removal Hello Anybody have any tips on removing the bearings from the swinging arm? I guess the obvious would be to use a socket and lump hammer, but would ideally like to use a puller of sorts. Any suggestions? Also would you advise replacing the large green o-rings on the concentric hub? TopiToo |
for the bearings i just warmed the arm up infront of a gas fire to get enough heat into it, then tapped it out with a socket and it near enough fell out. (burnt my hand on the arm though haha) as for the green O-rings, im just cleaning them up with water then using rubber grease and using them again. probably of no use but i have a copy of a genuine ducati manual if you need any info, i also have a full parts list with exploded diagrams and part numbers if you need it Adam |
Hello 748adam all done now thakyou you have a PM TopiToo |
All times are GMT +1. The time now is 19:06. |
Powered by vBulletin 3.5.4 - Copyright © 2000 - 2024, Jelsoft Enterprises Ltd.
© Ducati Sporting Club UK