Single Seat Conversion? I’m putting a single seat on my Bip 916 and using the parts from the twin seat, I think I will need to buy new: Plate 827.2.004.1A which is the plate that the striker bolts onto, it looks flatter than the BIP one? Spacers x 2 for the above bracket, Bolts x 2 for the above spacers, Anything else? |
They're the bits I bought for mine. Although I ended up buying a full set of everything in the end so it was an easier swap. |
Thanks, right let's see if they've got the bits in. |
Quote:
How much did all that cost in the end? |
About £40, though I did get the light unit off e-bay for peanuts. Most expensive new bit was the lock plate with the spigot on it, which was around £10.00 I think it's about £30 plus the light. |
Cheers Mr_S |
They've just charged me £30 for the plate that the latch plate bolts onto, and £5 for the spacers. Mr S did you have to cut the spacers down? The bolts are 60p each though. |
Didn't have to touch the spacers, just put them on. £30's a bit rich for a flat piece of steel with some holes in (I got a bargain then!) 60p for a bolt! Get a pair from somewhere else!!! |
To late now but where did you get your bits from? Mind you I did need them instantly as I'm MOT'ing the bike on Friday morning. |
hello walenut. did you get the parts fitted yet ? i just ordered and fitted the same parts . but my seat sits miles in the air. to me it looks like its needing dropped by an inch at least. if possible can you post or email a picture thnx |
All times are GMT +1. The time now is 02:19. |
Powered by vBulletin 3.5.4 - Copyright © 2000 - 2024, Jelsoft Enterprises Ltd.
© Ducati Sporting Club UK