Problems With Slipper Clutch
I recently bought a Bucci Clutch on ebay
The clutch disks were not the same from the instructions, but since I have some spare clutch disks I used them to obtein the instrutions disks compilations.
The problem is that when starting to move the bike, in a low engine rotation, every thing is fine, but if I rev the engine to 3500 rpm or more, at firts every thing seams fine, but then the bike jumps a lot and squils - makes funny noises - (sometimes it iven stalls) and finally stops the jumps and rolls ok.
I tryed a lot of thing to try to stop this:
- i've sanded the iron disks
- I add another iron disk to obtein a 38mm thick group of disks
but It keaps doing the same.
Every thing else is ok. The slipper clutch is work well when I Reduce gears and while rolling, the clutch is smooth like it sould.
Please try to gide me trough this problem
Is the outer basket in good condition, It could be the drive (Fibre Plates) catching
Bucci slipper clutch
Hello Lavras, you need to fit at least 2 new steel dished plates in the clutch pack and also there is a specific measurement required form the last clutch plate to the face of the clutch hub.
Give me a call tomorrow and I will explain what you need to do 02476335300
|All times are GMT +1. The time now is 10:59 AM.|
Powered by vBulletin 3.5.4 - Copyright © 2000 - 2017, Jelsoft Enterprises Ltd.
© Ducati Sporting Club