Hi Ime due at mallory tomorrow and have just changed the clutch on my 996SPS but have a snag. I have put the new clutch plates and metal plates back in exactly as they came out. The sequence was 2 metal the sintered/metal so in all 10 metal plates and 8 sintered. The problem after tightening up the springs the last plate is out of the basket and the clutch lever is rock solid, is it just a question of bleeding the clutch. Many Thanks Wosser
Have you lined the pressure plate up correctly with the clutch spring dowels?There is a mark on the pressure plate and a corresponding mark on the correct dowel.Make sure they are together.
Whats the measurement from the face of the last plate to the face of the hub. Should be between 4-5mm. Also is it a slipper, if so do you know who's. Std plates will not fit STM clutchs. What is the overall pack thickness.
Sorry that was a typo the pressure plate wasnt lined up with the marks, but fine now btw the standard plates for a 996 £88.00 , SPS ones (sintered) £160.00 I suppose I could have shopped around but didnt have any time Thanks again