Have Fitted a Yoyodyne slipper to 996 BP, purchased original Ducati sintered plates. But get bad noise when a standing start, have tried putting original(no sintered) clutch plate next to spacer closest to pressure plate thinking its this, but no luck. When riding all ok.
Am I better off using non sintered plates?, normal road riding.
Could some one post their clutch plate set-up. Including type of plates and spacers used. I've tried using dish plates and tried without, just spacer plates, still same.
I think (if I remember rightly from the conversation with the very more technically mined chap...) that it's the plates aligning themselves as they catch and hitting the basket that causes the screeching noise.
Check the plates. There is a "dot" on them. This should always face outwards. This is most likely the problem. Also check the correct the height of the stack with the manual. If you're not correct, the clutch will slip, it's partly your use of the clutch / your method. Get hold of a verner caliper, and make sure the depth is correct. This is imperative. If it's slipping a lot on departure, what can happen is that the clutch will eventuall collapse inwardly as you're placing too much pressure on the pressure plate, which, in time, will fracture - the voice of experience speaking here!