| advice needed for fitting female QR items on tank
Hi All
I am about to fit two new female quick release units to the bottom of my tank. (748 bip)
They were difficult enough to remove but can anyone give advise on the best way of fitting the new ones as they are awkward to get a spanner to to tighten up fully without damaging the connector.
How tight do they need to be is just over hand tight acceptable?
Would a bent spanner be appropriate?
All suggestions welcome.
Last edited by butchersdog : 25-Feb-2009 at 14:31. | 
25-Feb-2009, 14:23 
Threaded Mode