Do you feature in Viz with that name? Ventura do 2 different fitting kits for the alloy monoposto rear end and the steel framed bip rear end which yours must be if your taking a passenger. Might be worth checking. JUST CHECKED VENTURA CATALOGUE D013/B FITS ALL 998 BIP/MONO ALLOY AND STEEL FRAMES. WHEREAS D006/B FITS ONLY 998R & 998S ALLOY SUBFRAMES. Also can't tell from the photo but check the u shaped bracket isn't fitted upside down, but don't think it is. On mine, which is alloy mono kit the bolts clear the inner side of the seat but the L brackets just touch the bottom side of the seat unit so i always wrap some gaffa tape around the bracket at the contact point. same on my mates bike as well as it is a very tight fit. If you slacken all of the the bolts off a bit where the L brackets fit, and where the U bracket fits to the rear subframe you can get a little bit of play to move the brackets into the right position. The crucial one is getting the U braclet located in the right place as this governs how the L brackets sit. We're only talking a few mill of play here but it does make a difference. Hope that makes sense. If you're anywhere near Manchester you can check out how mine is fitted. Good luck. [Edited on 8-6-2005 by BDG] |