| Ventura Luggage Kit
Taking the bike on a long tour in August through Europe. Have used this system to great effect on my 748 and 998 in the past. I recently ordered it for my 999. The kit is comprised of two L shaped brackets that bolt at their front ends to the rear bolt of each respective pillion footrest (they also do a monoposto version in case you were wondering with naturally different brackets) and at their other end bolt to a U shaped bracket (that sits atop the rear silencer and mounts to the rear bodywork mounting points) to provide a rigid mount for the pack rack itself, (which is meant to be removable, leaving just the brackets on the bike) on which FINALLY !! you strap the luggage pack. Sounds complex but it is sooo simple to use. However heres the prob: With the termi system fitted, it seems as if the rear rack mounting bracket they supply will foul the termi carbon end can cover. Does anyone else have experience of this system and fitting it to this model. I have the instructions and it is as with all their stuff a well thought out bit of equipment and leaves you free to ride the bike and not be crippled by a huge rucksack, but this system though pupose made for this model was shown fitted to a Bip with the standard end can on and the OE heat cover. Worst case is I will have to remove the carbon heat shield. Worried that in doing so it will allow too much heat through to the bodywork, over which will be perched my other half !!  | 
Threaded Mode