Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > Wehey, got my zorsts back...

[Desmondo]

"The Slut" MkII is underway. Hopefully with a new paint job ready for the DSC Cadwell day.

[antonye]

Originally posted by Desmondo
"The Slut" MkII is underway. Hopefully with a new paint job ready for the DSC Cadwell day.

Work is well underway on The Slut's little sister too

Antonye, that remark is soooooo Essex ....

[smilo006]

Along the same lines.
Currently have 2 sets of carbon exahusts. One with polished ends (996R) and one without (996S). The carbon on the 996R ones is on the way out, therefore thought about swapping the carbon over.
Seen the maintenance kit (£500 here) but only really need one clip and the rivets. Ducati dealer cannot source them alone.

Can you get em (MHP perhaps) and is it possible to DIY this job. Asked my friendly Ducati dealer in Denmark and he wants likely over £100 to do the job.



If you think Ducati's are expensive come to Denmark! 996S that will be 30K to you.

[AK]

Call Mark at MHP 01483 473473, he is brill.
(also one of AK's best mates) Fixed my can that AK kindly mullered last Sat, in a jiffy... ok about 2 hours on Monday night, and also re-polished up the other - buffing the weeny scratch out of it.
Did a good dyno run on AK's bike too last week, putting more out than the std 900ssie should

C