if so you will need to change the bracket thats about all,
to fit a mono seat to a bip frame you need an angled bracket and spacers, assuming you or someone else has already done this, you just need to return it to std with a flat bracket and no spacers ie shorter screws
if you have a bip seat then i dont belive that it will mount on the mono frame
On the alloy Mono subframe for the 748R the 1.6M Ecu sits across the back of it, rotated 90 degress from the plain in which it sits on the BP subframe, this means the multiway connector is slightly futher back, a bit of careful rerouting of the injection harness can be done to allow it to cope with this extra distance, although repositioning of the air temp sensor or lengthening its 2 wires may be required. I haven't done it myself but I know Karl the Oxon/Berks RO has done it
Mood: All that is necessary for the triumph of evil is that good men do nothing
I tried to do this on my "S" but the big connector came up short no matter how carefully I routed the cables, so I just gave up in the end, life's to short!
I tried to do this on my "S" but the big connector came up short no matter how carefully I routed the cables, so I just gave up in the end, life's to short!
John did your S have the later temp sensor unit that does away with the MAP sensor on top of the header tank