Private Adverts Use this forum for all private adverts. You must have been a registered member on this board for at least 14 days before you are allowed to post.
I'm wondering if anyone here has one of those "tubes" that act as side fairing stays on a carby SS - it bridges the gap between chassis and side fairing.
I'm after another after I bludgeoned to one death on my DD bike. Would be enormously grateful, and of course payment would be due! PM if you can help. Thx.
Hi Jason, one mod I used (but cant remember where I got it from) was to pull out the rubber grommets in the tube and use a single very long bolt that is the full length of the tube + a little extra.
I found a supplier that sold bolts longer enough that with a few washers and a nyloc nut on the end I could get a rock solid fit.
I'm hoping to get some replacements made in the way of a inch wide stainless "Z" bracket that will allow the use of Dzus fasteners as I to need to replace the one on my race bike after my off at Mallory