The manual for the 748R, which has an Ohlins, says: Shock absorber adjusters (fig. 18) The shock absorber has outer adjusters that enable you to adjust your motorcycle to the load. The adjuster (1) located on the left side, on the connection holding the shock absorber to the swingarm, controls rebound damping. The adjuster (2) on the shock absorber expansion reservoir controls compression damping. Turn the adjusters (1 and 2) clockwise to increase damping, anticlockwise to reduce it. STANDARD setting: turn the adjusters (1 and 2) all the way in (clockwise) then slacken them 14 clicks. Two ring nuts (3), located on the top section of the shock absorber are used to adjust the outer spring preload. To change spring preload, slacken the upper ring nut. Then tighten or slacken the lower ring nut to increase or decrease spring preload as required. |