Ducati Sporting Club UK > DesmoDue Race Series > DesmoDue - General Questions and Chat > Custom made washers, where from?

[Tonio600]

I need some custom made washers so that I can easily swap from a 620 rear wheel to a 600 one on the Monster. Dimensions should be 17mm ID, 24mm OD and 2mm thick. Well OD does not matter too much actually.

Any idea where I can source such bits?

[Chris Wood]

Rich Casmore? Doesn't he run a fastners business??

[rich-racing.co.uk]

you'd need to know somebody it the trade....

stock 16mm washers will have clearance on, 2mm thick but smallest OD standard is 30mm.
can you get by with this?

24mm - 17mm = 7mm. half of this either side 3.5mm. not much of a washer..

remind me of your address and I'll fix you up.

[Tonio600]

Hi Rich,

Thanks for your offer of help mate.
Indeed, they're more spacers than washers but a fellow ducatisti offered to make them for me. I'll PM you my address anyway for another business we had to finish

Cheers,

Tonio.

[rich-racing.co.uk]

Originally Posted by Chris Wood

Rich Casmore? Doesn't he run a fastners business??

running it into the ground.......

[Chaz]

Originally Posted by Tonio600

Hi Rich,

Thanks for your offer of help mate.
Indeed, they're more spacers than washers but a fellow ducatisti offered to make them for me. I'll PM you my address anyway for another business we had to finish

Cheers,

Tonio.

If they are spacers I should be able to turn those for you just need a bit of a drawing with dimentions.

[Tonio600]

Thanks for the offer Chaz, but a fellow Ducatisti is already on the case