From the manual (may help) In the event of replacement of one or more components of the immobilizer system (e.g. the black keys, the decoder, or the engine control unit), the parts in question must be programmed. To perform this operation, proceed as follows: - check that the motorcycle battery terminals are correctly connected and that the battery is in perfect condition. - Prepare the red key and the black keys. - Insert the red key (2) in the ignition switch (3). - Turn the key to the ON position to switch on the instrument panel. The instrument panel multifunction display will show the CODE symbol, the number of keys inserted (“1” in this case) and start a countdown from 30 to 0. Note: before performing this action ensure that the ignition switch remains in the OFF position for at least thirty seconds. - Check that the countdown has started and turn the key to OFF before it terminates (around three seconds). - Remove the red key within 15 seconds, insert a black key (4) and turn the switch to ON. Display will show the number of keys inserted (“2” in this case) and start a countdown from 30 to 0. - Check that the countdown has started and turn the key to OFF before it terminates. - Remove the black key within 15 seconds, insert another black key (5) and turn the switch to ON. Display will show the number of keys inserted (“3” in this case) and start a countdown from 30 to 0. - Check that the countdown has started and turn the key to OFF before it terminates. - Remove the black key within 15 seconds, insert the red key again and turn the switch to ON. The display will show the number of keys inserted (“4” in this case) and start a countdown from 30 to 0. - Check that the countdown has started and turn the key to OFF before it terminates. If the programming sequence has terminated successfully, the led (A) on the instrument panel will flash. At this point the two black keys and the instrument panel decoder have been successfully programmed. Continue the procedure as follows: - turn the ignition to ON with the red key within 15 seconds. The CODE symbol on the display will switch off. - Leave the key in the ON position for at least 5 seconds and no more than 15 seconds, to allow the data to transfer from the decoder to the engine ECU and then turn the key to OFF. - Wait for 10 seconds, then turn the ignition switch to ON again. The programming procedure is now terminated. The immobilizer system has been completely programmed. Even if you need to program only one component of the immobilizer system, always run the entire procedure. At the end of the procedure, check that the engine can be started with the black keys. Warning If display shows the message “OFF” during the procedure, this indicates that the programming routine has been aborted. Repeat the procedure from the beginning. To ensure that the immobilizer is correctly programmed, you must scrupulously observe the timings and other conditions indicated. |