Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > Symptons of worn clutch basket

[Glyn]

Originally posted by zhed44

is he talking about changing the plates or the basket?

about assessing the job

[andyb]

who Fordie...............

If you need/want to change the drum you need a big socket, torque wrench and a clutch holding tool.

[Fordie]

Better still AndyB, you need NELLY Actually changing the basket is a little more involved and special tools are reguired,as you say not a DIY job really. 4D

[Glyn]

its not hard pete
i managed it
as andy says you do need a cluth holding tool also a bloody big torqe wrench
to just assess the condition though is as you say a very easy job

[andyb]

Originally posted by Fordie
Better still AndyB, you need NELLY Actually changing the basket is a little more involved and special tools are reguired,as you say not a DIY job really. 4D

Its not actually that big a job, even with a slipper. your right though if in doubt get it done by someone that knows........and has the kit!

[Glyn]

i nearly popped a testie trying to do that damn nut up

[rockhopper]

The service limit on the basket is a lot less than the amount of wear that actually starts to cause a problem if that makes sense!!

In other words you are supposed to change it but in reallity it will keep on working for ages.

Symptoms are jerky clucth release as the plates slide over the notches in the basket fingers. You can dress them out with a file though. This will result in more noise unless you are running ST4S alloy clutch plates.

[andyb]

Originally posted by Glyn
i nearly popped a testie trying to do that damn nut up

i could of leant you the tool.tool.... You in tomorrow?

[flanagaj]

Looks as though the plates and basket have worn. In the Haynes Manual it says that if the engine is in the frame you can just put it in gear, press the back brake on hard and remove the clutch without any special tools.

Is this correct ?

PS - Should I go standard basket and plates or buy a slipper ?

Either way can anyone drop me details as to where the best place to buy is ?

Thanks

[rockhopper]

Really depends on how good your back brake is and if you have someone to help you. I think the big nut is something like 180N/m. Some people put bits of wood through the back wheel. If you've got an old set of plates, some half inch bar and a welder you can make a clutch holding tool.