lockwiring sump plug???

jacknash · 01-Jul-2003, 19:58

how do i go about lockwiring the sump plug, it seems to be flush mounted, does anyone supply pre-drilled plugs?

thanks folks

skidlids · 01-Jul-2003, 22:35

I drilled a small hole from the outer flat surface through into the hex at a angle of around 45 degrees, only took a couple of minutes.
I think anr performance may do drilled ones http://www.anrperformance.co.uk/

998Addict · 02-Jul-2003, 09:32

See the thread in General Messages from a couple of weeks ago, entitled "lockwiring".

I made a big post there, which should hopefully help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

01-Jul-2003, 19:58	#1
jacknash Registered Forum User Mille Posts: 107 Join Date: Jun 2002 Location: N Hampshire lockwiring sump plug??? how do i go about lockwiring the sump plug, it seems to be flush mounted, does anyone supply pre-drilled plugs? thanks folks Reply

01-Jul-2003, 22:35	#2
skidlids MotoGP God Posts: 18,274 Join Date: Apr 2002 Location: Oxford Mood: Its ONLY a Bike Club I drilled a small hole from the outer flat surface through into the hex at a angle of around 45 degrees, only took a couple of minutes. I think anr performance may do drilled ones http://www.anrperformance.co.uk/ Reply

02-Jul-2003, 09:32	#3
998Addict Registered Forum User Mille Posts: 150 Join Date: Jun 2002 Location: Edinburgh, Scotland Mood: Pensive See the thread in General Messages from a couple of weeks ago, entitled "lockwiring". I made a big post there, which should hopefully help. Reply