Wanted: SS side fairing stay

JasonBoswell · 30-Jun-2009, 14:23

Hiya,

I'm wondering if anyone here has one of those "tubes" that act as side fairing stays on a carby SS - it bridges the gap between chassis and side fairing.

I'm after another after I bludgeoned to one death on my DD bike. Would be enormously grateful, and of course payment would be due! PM if you can help. Thx.

Jason.

Dominic Clegg · 01-Jul-2009, 01:04

Jason I got two let me know still need them

Iconic944ss · 01-Jul-2009, 02:47

Hi Jason, one mod I used (but cant remember where I got it from) was to pull out the rubber grommets in the tube and use a single very long bolt that is the full length of the tube + a little extra.

I found a supplier that sold bolts longer enough that with a few washers and a nyloc nut on the end I could get a rock solid fit.

Cheers - Frank

skidlids · 01-Jul-2009, 08:55

I'm hoping to get some replacements made in the way of a inch wide stainless "Z" bracket that will allow the use of Dzus fasteners as I to need to replace the one on my race bike after my off at Mallory

ali · 01-Jul-2009, 09:00

I used to use a long bolt through a bit of fuel hose. The bit of fuel hose makes sure the fairing doesn't rattle along the bolt. Worked fine.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

01-Jul-2009, 01:04	#2
Dominic Clegg Registered Forum User Big Twin Posts: 1,354 Join Date: Sep 2005 Location: Bradford Mood: DD 2006: 4th Top Rookie. DD 2007: 2nd Class B. DD 2008: 2nd Class B. Jason I got two let me know still need them Reply

01-Jul-2009, 08:55	#4
skidlids MotoGP God Posts: 18,274 Join Date: Apr 2002 Location: Oxford Mood: Its ONLY a Bike Club I'm hoping to get some replacements made in the way of a inch wide stainless "Z" bracket that will allow the use of Dzus fasteners as I to need to replace the one on my race bike after my off at Mallory Checkout the Desmo Due Paddock on Facebook Reply

01-Jul-2009, 09:00	#5
ali Registered Forum User Ducati Meccanica Posts: 2,463 Join Date: May 2004 Location: Guernsey Mood: Damp I used to use a long bolt through a bit of fuel hose. The bit of fuel hose makes sure the fairing doesn't rattle along the bolt. Worked fine. Reply