HT leads

aka.eric · #1 28-Jan-2006, 17:15

Need a lead for the vertical cylinder,imagined it would be simple to order one from dealer.However,they supplied the wrong one,too short,horizontal cylinder and since 16 December nothings arrived.Is it possible to use a "universal" lead,thinking about the rubber boot at the plug end.Also at £20+ each the original leads are not cheap.

nelly · #2 29-Jan-2006, 12:24

I've not seen any readily available aftermarket ones. Drop me a mail and i'll have a look in the cupboard

I have a few in there that may work??
Can you measure the length and quote that on the mail to.

aka.eric · #3 29-Jan-2006, 12:35

Thanks,its the same as a lead for the 748/9-- series,part no 67110011A.

nelly · #4 29-Jan-2006, 12:39

I reckon you're in luck then

Drop us a mail and i'll try and sort it tomorrow.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit