Monster 600 1995

GsxrAge · 15-Jan-2005, 15:45

Had the monster running and it died out and would not start again. checked plugs and the plug on rear cylinder was sparking inside the plug not on the point.
It has done this before last time fitted new plugs and all ok.
It has correct ngk plugs fitted do monsters have a tendecey to go through plugs ????

Ideas anyone (shazam nelly)

[Edited on 15-1-2005 by AGE996]

Albie · 15-Jan-2005, 19:51

Ive had 2 occasions where plugs have gone quickly. I changed to shell optimax all the time and no problem since

AK · 15-Jan-2005, 20:03

Change plugs (or clean up, saves dosh), cos the rear one is now fouled & is shorting.

This does sometimes happen when starting.

If still doing it, check compression, cos if low will foul plugs.

I have fitted/sold some of the guys in the monster club some iriduim plugs, as these seemed to help with the older bikes.
Run ours on these too as starts better.
M600 plug: DPR9EIX-9 - stock number is 5545 for NGK

Alan

GsxrAge · 15-Jan-2005, 21:15

have tried cleaning them but no good

will get a new set next week thanks

AGE

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

15-Jan-2005, 19:51	#2
Albie Registered Forum User 500SD Posts: 755 Join Date: Aug 2004 Location: Rochester Kent Ive had 2 occasions where plugs have gone quickly. I changed to shell optimax all the time and no problem since Reply

15-Jan-2005, 21:15	#4
GsxrAge Registered Forum User Big Twin Posts: 1,868 Join Date: Jul 2004 Location: Wellington somerset have tried cleaning them but no good will get a new set next week thanks AGE Reply