Wanted Marchinesini front wheel and exhaust camshaft for 996 SPS

kevski · 30-Dec-2009, 14:14

As the title says wanted Marchinesini front wheel (would prefer standard gunmetal grey) and exhaust camshaft for 996 SPS

both must be in good serviceable condition, can exchange for similar parts that could be useful as door stops.

cheers

nelly · 30-Dec-2009, 21:28

Quote:

Originally Posted by kevski

As the title says wanted Marchinesini front wheel (would prefer standard gunmetal grey) and exhaust camshaft for 996 SPS

both must be in good serviceable condition, can exchange for similar parts that could be useful as door stops.

cheers

Which cylinder i sthe exhaust cam for?

kevski · 31-Dec-2009, 10:06

Rear, so should have SA cast on it and T1 engrave in it for an SPS.

pguenet · 31-Dec-2009, 23:47

If you are interested I have a new set of G exhausts.

kevski · 01-Jan-2010, 11:40

Hi, excuse my ignorance but I assume G exhaust are of a different profile?

Can you point me at what the difference is and will this get me into needed to re pocket the pistons if higher lift etc?

To be quite honest I’m not really after chasing more HP as std spec is enough, just want to find the most economical way to do the job correctly.

Cheers

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

31-Dec-2009, 10:06	#3
kevski Registered Forum User Bikes: 996 SPS Posts: 25 Join Date: Sep 2009 Location: surrey Rear, so should have SA cast on it and T1 engrave in it for an SPS. Reply

31-Dec-2009, 23:47	#4
pguenet Registered Forum User Big Twin Posts: 1,413 Join Date: Aug 2002 Location: Surrey If you are interested I have a new set of G exhausts. Reply