Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 999 / 749 > Termi can/ filters fitting

[yellowisfriedegg]

Originally posted by keefer
well i wouldn't remove the sub frame but just undo the bottom two nuts and slacken of the top two then leaver it up, you can then access the cans.
firstly though remove the seat then tank so you can put your trick filter in

sound advice about the subframe . detach the seat part from the tank for clearance , 17mm bolt under in centre.

You don't remove the tank on 749/999 to fit the filters , it's top fairing off I'm afraid and then remove airtubes , 3 x 5mm allen screws , old filters out new filters in , re-fit airtubes and top fairing.

easiest was to fit ecu is remove battery , disconnect wire to front plug , sidestand and sensor , unbolt battery box housing and swing out towards rear of bike , ecu has 2 small bolts through from outside and then open the cam locks on the connector pins to remove , fit new ecu and reverse the procedure.

if it is a full system you are fitting , don't forget to fit the spacer kit to the r/h footrest mount for clearance.


...............have fun