Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > Advice Wanted Brembo CNC Calipers and Levers

[Dazza]

Im after some info about Brembo braking components:

Brembo PR16 Radial Master Cylinder Brake lever

Brembo PR19 Radial Master Cylinder Brake Lever

Brembo Clutch RAdial Master Cyl Lever (size??)

Difference between Cast and CNC/billet Levers in terms of quality and performance?
What difference do the sizes and lever lengths make, what sizes and lengths are avalable?

Can i fit the brake light switch to the Radial Lever, is this an easy mod?

Brembo Racing GP P4 30/34A CNC Calipers
Brembo Racing P4 32/36 calipers
Brembo Goldline 4 Pad Calipers

Difference in performance between these calipers.

I will be using Brembo Cast Iron floaters 320mm - could i use P4 32/36 calipers?
I have Ohlins RT forks with 40mm replacable caliper brackets so i could go to 65mm - but I see that CNC P4 Brembo Calipers are 40mm and only the new 4 Pad Goldline calipers are 65mm, is this correct?

Will I have to change brake fluid resevoirs if I use radial pump levers?

Best brake lines to use?

Is it worth upgrading the rear Caliper to a Brembo CNC 2 or 4 pot caliper ?

Waht overall performance increase will I see if I upgrade the whole braking system to CNC Calipers and Levers, over the standard goldline brembo parts?

And finally, anybody know where i can get a catalog and some technical info, maybe a pdf to download (not the Ducati performance catalog)?

Thanks!
D.

Be Happy Everybody

[Edited on 18-8-2003 by Dazza]