Quote:
| Originally Posted by polarexpress Are you referring to the Corse mag swingarm, Chris?
If so those large 55mm 12-sided nuts aren't made of Ti. They are hard anodized Al-nuts. The eccentric pinch bolts and the cush drive nuts are made of Ti, however.
The torque values are as follows:
- Lefthand sprocket carrier nut: 235 Nm.
- Righthand wheel nut (L/H tread): 295 Nm.
The reason the torque values are significantly higher than the stock ones are due to the much coarser thread on the Corse nuts.
Good luck! |
No they are for the standard swingingarm. They are from MPL Tuning and are standard size, just 12 sided & are Titanium.
Chris.
29-May-2006, 14:04 
Threaded Mode