Quote:
| Originally Posted by B19PSK Once the alarm is installed and working correctly.
Carefully remove the lid (Torx) and seal up the cable entry as much as possible (Silicon sealer) then spray "Conformal coating" on both sides of the PCB and connector (with the wires attached). This will coat the electronics is a plastic coating making it much more waterproof. While your in there replace the NiMH battery for a new one at least 2100mAH size or better, £3-4 on Ebay. Any probs on the Conformal contact me.
Regards
Paul |
Many thanks, ill open it up at the weekend and give it a good spray, Im surprised the alarm PCB is not encased already in plastic.
Whats the point of the bigger battery?
01-Jun-2006, 21:28 
Threaded Mode