 |
| | |||||||||||||||||||||||||||
| | Thread Tools | Search this Thread | Display Modes |
| #1  10-Jul-2012, 11:54 | ||||
| ||||
| Grab rails Tech specs suggest grab handles can be removed. It then goes on to mention “Any cutting should take place 1cm from the weld on the side furthest from the main Subframe rail.”, however, the picture in the regs of a monster frame shows no rails at all?  Do I need to cut 1cm from the weld or is that only applicable to the rear tea-tray support rails? Seems a bit daft (and maybe dangerous?) to leave 1cm of the grab rail sticking out?  Once I’ve cut the rails off, what do you fill the hole with? I’m going to get the frame powdercoated so wondering what you would recommending to plug the gap? cheers!  |
Threaded Mode